Hook Eye Turnbuckle Thimbles Swages Short Eye Bolt SRMM - Eye Bolt, Metal, None, 316, Under 10M (SR), 4-0mm, Turnbuckle - Eye/Hook Open

Low Cost Wire
Hook Eye Turnbuckle Thimbles Swages Short Eye Bolt SRMM - Eye Bolt, Metal, None, 316, Under 10M (SR), 4-0mm, Turnbuckle - Eye/Hook Open
Hook Eye Turnbuckle Thimbles Swages Short Eye Bolt SRMM - Eye Bolt, Metal, None, 316, Under 10M (SR), 4-0mm, Turnbuckle - Eye/Hook Open
Shop all Nut & Bolt Sets

Hook Eye Turnbuckle Thimbles Swages Short Eye Bolt SRMM

Hook Eye Turnbuckle Thimbles Swages Short Eye Bolt SRMM kit suits a run of wire of 10 meters or less (hence the SR or Short Run). There a single tensioning point and two attachment points. Attachments are two M6x1.0x15mm (Short or Mini) Eye Bolts. These attach directly into metal posts (hence the MM or Metal to Metal) and we recommend the use of an M6 combination Drill Tap or Nutserts.

Application

The first end of the run has a Hook Eye Turnbuckle (for wire tensioning) swaged to the wire. The hook of this attaches to the first Eye Bolt. The eye attaches to the wire using a terminal loop formed with a ferrule and a swage. The Eye Bolt is fastened to a metal post or stud. The second end uses a terminal loop formed with a ferrule and a swage to attach to the second Eye Bolt which is fastened to the second post or wall.

Wire may be installed through the intermediate posts and 'cut to length'. Please make sure you expand the turnbuckles before measurement and drill the intermediate posts out to at least 4mm prior to swaging in place. Alternately, if you build the wire before you install it, then the length of a wire run is determined by the 'inside to inside' post measurement less a fixed amount which represents the distance between the attachment posts 'taken up' by the fittings when installed and adjusted properly.

We therefore recommend our Drill Taps (for drilling and tapping the metal posts) for installation of the Eye Bolts. Additionally, you can use Nutserts which afford an excellent structural alternative. Also - in your intermediate metal posts - we strongly recommend the use of stand grommets (flat areas) and angle grommets (ramps or stairs) for any non-stainless intermediate posts (to avoid a dissimilar alloys reaction).

Contents

  • 2 - M6x1.0 x 15mm Eye Bolts Stainless Steel 316 Marine Grade
  • 1 - Hook Eye Turnbuckle G316 Stainless Steel Marine Grade
  • 2 - Nickel Coated Copper Ferrules
  • 2 - G316 Stainless Steel Thimbles

Characteristics

  • Balustrade Kit for 1 Runs/Wire
  • Post Connections MM (Metal to Metal) (Nutserts are optional)
  • Recommended Run Length <10M (SR)
  • Swaging Method: Manual
  • Wire Structure: 7x7, 7x19
  • Diameter of Wire: 1.6mm, 2.0mm, 2.4mm 3.2mm 4.0mm
  • Section Orientation: Flat, Stairs, Angle
  • Wire Orientation in a Section: Horizontal, Vertical