Jaw Jaw Rigging Screw Thimble Swage Long Screw Eye LRTT - Eye Screw, None, Over 10M (LR), 3-2mm, Turnbuckle - Jaw/Jaw Closed

Low Cost Wire
Jaw Jaw Rigging Screw Thimble Swage Long Screw Eye LRTT - Eye Screw, None, Over 10M (LR), 3-2mm, Turnbuckle - Jaw/Jaw Closed
Shop all Other

Jaw Jaw Rigging Screw Thimble Swage Long Screw Eye LRTT

Jaw Jaw Rigging Screw Thimble Swage Long Screw Eye LRTT Kit suits a run of wire of 10 meters or more(hence the LR or Long Run). There are two tensioning points and two attachment points. attachments are two 6mm x 75mm (Long) Lag Eye Screws. These attach directly into softwood or hardwood timber posts (hence the TT or Timber to Timber).

Application

The first end of the run has a 5mm Jaw / Jaw Rigging Screw (for wire tensioning) swaged to the wire. The jaw of this attaches to the first 75mm Screw Eye. The other Jaw attaches to the wire using a terminal loop formed with a ferrule and a swage. The Screw Eye is fastens to a timber post or wall. Repeat the procedure to fasten to the second post or wall.

Wire may be installed through the intermediate posts and 'cut to length'. Please make sure you expand the turnbuckles before measurement and drill the intermediate posts out to at least 4mm prior to swaging in place. Alternately, if you build the wire before you install it, then the length of a wire run is determined by the 'inside to inside' post measurement less a fixed amount which represents the distance between the attachment posts 'taken up' by the fittings when installed and adjusted properly.

This kit may also be used for 'infill' balustrading with the addition of extra Long Lag Screw Eyes.

Contents

  • 2 - 6mm X 75mm Lag Eye Screw Stainless Steel 316 Marine Grade
  • 2 - 5mm Jaw/ Jaw Rigging Screw G316 Stainless Steel Marine Grade
  • 2 - Nickel Coated Copper Ferrules (size depends on chosen wire diameter)
  • 2 - G316 Stainless Steel Thimbles (size depends on chosen wire diameter)

Characteristics

  • Balustrade Kit for 1 Runs/Wire
  • Post Connections TT (Timber to Timber), TC (Timber to Concrete), CC (Concrete to Concrete)
  • Recommended Run Length **>**10M (LR)
  • Swaging Method: Manual
  • Wire Structure: 7x7, 7x19
  • Diameter of Wire: 2.0mm, 2.4mm, 3.2mm, 4.0mm
  • Section Orientation: Flat, Stairs, Angle, Infill
  • Wire Orientation in a Section: Horizontal, Vertical, Angled