1 1/2 inch Threaded Tank Inlet Bulkhead w/ Rubber Washer for Irrigation Fittings

Threaded Tank Inlets are also known as bulkheads. They are used for joining irrigation fittings through water tanks, poly ponds, container, pond liner and anything with a smooth flat surface. The heavy duty nuts and rubber washers seal against a wide range of surfaces. Tighten securely using a pipe wrench or shifter - the nylon hex shaped nut and head will not round off easily.

Tank Inlet Features

Strong, durable and long lasting nylon construction
Screw on PVC BSP fittings on either end - one female and one male connection on each end
Long thread to go through up to
1/2, 3/4, 1, 1 1/14, 1 1/2 and 2 inch sizes available
Corresponding to 13, 19, 25, 32, 40 and 50mm sizes (metric) available

Tank Inlet Detailed Specifications

13mm Tank Inlet / Bulkhead
13mm Female BSP inlet
13mm BSP Threaded Tail, 75mm long tail, with 55mm maximum width for the back nut to still tighten.
60mm diameter rubber washers from a strong seal

19mm Tank Inlet / Bulkhead
19mm Female BSP inlet
19mm BSP Threaded Tail, 75mm long tail, with 55mm maximum width for the back nut to still tighten.

25mm Tank Inlet / Bulkhead
25mm Female BSP inlet
25mm BSP Threaded Tail, 75mm long tail, with 55mm maximum width for the back nut to still tighten.

32 / 40mm Tank Inlets / Bulkheads
32/40mm Female BSP inlet
32/40mm BSP Threaded Tail, 75mm long tail, with 50mm maximum width for the back nut to still tighten.

50mm Tank Inlet / Bulkhead
50mm Female BSP inlet
50mm BSP Threaded Tail
Total tail length is 75mm
Back nut is anticlockwise thread, slightly larger than 50mm, and only 25mm maximum width for the back nut to tighten and seal through a wall
The 50mm threaded tail is 25mm long after the larger backnut thread.
93mm diameter rubber washers, total nut diameter is 95mm
;