Wj01 Aluminum Alloy Black Bicycle Rack Bike Rack Rear Rack Shelf Cycling Equipment Accessory

Features:
1. Main body made of high-strength aluminum alloy, fine workmanship plating paint, prolong the service life, make the shelf more practical, strong and light.
2. According to different requirements, telescopic installation, adjustable design increases universal performance, basically in line with most mountain bikes.
3. Detachable side wing, can be removed when not needed, crash bar structure, easy to install luggage bag, effectively prevent the friction of the luggage bag and tires.
4. The top of the bracket clamp is fixed with screws, which can be adjusted according to the size of the back screw, easy to install, and greatly improve the overall performance.
5. Adopts the rhomboid support clamp, the versatility and firmness are comprehensively improved, after installation, two small triangles are supported, left-right swing immunity is more obvious. For disassembly, a wrench hex is needed

Specifications:
Condition: 100% Brand New
Item Type: Bike Rack
Model: WJ01
Material: Aluminum Alloy
Color: Black
Weight: approx.1000g
Size: approx.50 cm / 19.69 inches

Structural breakdown:
Scratch-resistant gasket
Bike rack surface
Bike rack surface adjustment screw
Rear light
Main body
Main body quick release head
Side wing
Fixed support rod screws
Fixed support rod

Adjusting the bicycle rack:
1. First loosen the three screws under the main body with an inner hexagon wrench
2. After the screw is loosened, you can adjust the installation angle and choose the angle suitable for your own needs to tighten

Installation of the support rod
1. Each support clip is equipped with a seal, the role is to protect the frame, the installation must be placed in the correct position
2. After the gasket is placed correctly, tighten the support flange on the back of the frame and the upper pipe, tighten the screw, tightening is also necessary to pay attention to the gasket gasket in the correct position
3. After installing the support clamp, loosen the screws on the support rod to adjust the length of the support rod
4. Tighten the screws and washers after adjusting the height, then tighten the screws used to adjust the length of the support rod

Mounted on both sides and the taillight
1. The two wing side mounting frames are mounted on the front and rear screw holes
2. The two side wings mounted directly with screws and gaskets
3. After blocking the reflector, check it again (angle, screw, joint, etc.)

Package list:
1 x bicycle rack
6 x scratch-resistant gasket
7 x surface adjustment screws
7 x nut
7 x accessory
1 x rear light
2 x side fender
4 x fixed support rod
1 x hanging rope